vmware config process

Run /usr/bin/vmware-config.pl to config the vMware interface settings

Would you like to skip networking setup and keep your old settings as they are?
(yes/no) [yes] no

Do you want networking for your virtual machines? (yes/no/help) [yes]

Would you prefer to modify your existing networking configuration using the
wizard or the editor? (wizard/editor/help) [wizard] editor ==> use editor to add the vmware vmnet <==> physical interface mapping

The following virtual networks have been defined:

. vmnet0 is bridged to eth0
. vmnet1 is a host-only network on private subnet 172.16.198.0.
. vmnet2 is bridged to eth1
. vmnet3 is bridged to eth2
. vmnet8 is a NAT network on private subnet 172.16.126.0.

Do you wish to make any changes to the current virtual networks settings?
(yes/no) [no] yes

Which virtual network do you wish to configure? (0-99) 4

What type of virtual network do you wish to set vmnet4?
(bridged,hostonly,nat,none) [none] bridged

Configuring a bridged network for vmnet4.

Your computer has multiple ethernet network interfaces available: eth3, eth4,
eth5, eth6, eth7, eth8. Which one do you want to bridge to vmnet4? [eth0] eth3

The following virtual networks have been defined:

. vmnet0 is bridged to eth0
. vmnet1 is a host-only network on private subnet 172.16.198.0.
. vmnet2 is bridged to eth1
. vmnet3 is bridged to eth2
. vmnet4 is bridged to eth3 ==> The new added one interface
. vmnet8 is a NAT network on private subnet 172.16.126.0.